Gauge R&R Basics
How to tell whether your measurements can be trusted. An online lesson, a test and a certificate of training for the plant's files.
Why customers ask about this
Customers who buy to a measured specification may ask a supplier to show that its gauges and its people measure consistently. This course explains repeatability and reproducibility in plain words and walks through a simple study.
What the lesson covers
- Why measurements vary
- No measurement is perfect
- Where the error comes from
- What a poor measurement does
- Accuracy, precision and calibration
- Accuracy and precision are different things
- Four dartboards
- Calibration is not Gauge R&R
- Calibration or Gauge R&R?
- Repeatability and reproducibility
- Repeatability
- Reproducibility
- Which one is it?
- Together
- Running a simple study
- The standard set-up
- Keep it honest
- The study, start to finish
- Reading the result
- Percent Gauge R&R
- The common guideline
- Which part is bigger
- Go/no-go and visual checks
- Checks without numbers
- An agreement study
- Fixing a poor result
- When repeatability is the problem
- When reproducibility is the problem
- Fix the gauge, or fix the method?
- Then run the study again
What each person gets
- A self-paced lesson with drawings and short activities, on a computer or a phone.
- A knowledge check at the end of each module.
- A 15-question final test. 12 correct to pass, and it can be retaken.
- A dated certificate of training with a number that a customer or auditor can check on this site.
- A take-away for the plant's files: Gauge study worksheet.
The certificate is a certificate of training. It is not an accreditation or a certification of the plant.
Related guides
$49 per person. This course opens soon. Leave your email and we will tell you when, or start with the free introduction course today.
Tell me when it opens See the free course